Code Library › Volume 1 › Section 9.20 — Masonry and Insulating Concrete Form
PART 9 — HOUSING AND SMALL BUILDINGSUpdated for the 2024 Ontario Building Code

9.20.11.1.Anchorage to Floor or Roof Assemblies where Masonry Walls Require

Lateral Support (1) Where required to receive lateral support (See Subsection 9.20.10.), masonry walls shall be anchored to each floor or roof assembly at maximum intervals of 2 m, except that anchorage to floor joists not more than 1 m above grade may be omitted. (2) Anchors required in Sentence (1) shall be corrosion-resistant and be not less than the equivalent of 40 mm by 4.76 mm thick steel straps. (3) Anchors required in Sentence (1) shall be shaped to provide a mechanical key with the masonry and shall be securely fastened to the horizontal support to develop the full strength of the anchor. (4) When joists are parallel to the wall, anchors required in Sentence (1) shall extend across not less than 3 joists.
← Previous9.20.10.1. Lateral Support RequiredNext →9.20.11.2. Bonding and Tying Intersecting Masonry Walls whe

Common questions about this part of the code

How must brick veneer be supported and tied to a house in Ontario?How thick do above-grade masonry walls have to be in Ontario?What are the Ontario Building Code rules for above-grade ICF walls in houses?

Understand this provision in seconds

BUILDAiD Assist explains any article of the building code in plain English — with exact citations, exceptions and related requirements.

Try BUILDAiD Beta

Code text is reproduced for reference from the Ontario Building Code (O. Reg. 163/24, 2024 Building Code Compendium). This page is provided for general information and is not an official copy. Always verify requirements against the official Ontario Building Code and confirm with your local building department.