Code Library › Volume 1 › Section 9.20 — Masonry and Insulating Concrete Form
PART 9 — HOUSING AND SMALL BUILDINGSUpdated for the 2024 Ontario Building Code

9.20.6.2.Cavity Walls

(1) Cavity walls shall be made with not less than 90 mm wide units if the joints are raked and not less than 75 mm wide units if the joints are not raked. (2) The width of a cavity in a cavity wall shall be not less than 50 mm and not greater than 150 mm. (3) The minimum thickness of cavity walls above the supporting base shall be 230 mm for the top 7.6 m and 330 mm for the remaining portion, except that where 75 mm wide units are used, the wall height above the top of the foundation wall shall not exceed 6 m.
← Previous9.20.6.1. Thickness of Exterior WallsNext →9.20.6.3. Thickness of Interior Walls

Common questions about this part of the code

How must brick veneer be supported and tied to a house in Ontario?How thick do above-grade masonry walls have to be in Ontario?What are the Ontario Building Code rules for above-grade ICF walls in houses?

Understand this provision in seconds

BUILDAiD Assist explains any article of the building code in plain English — with exact citations, exceptions and related requirements.

Try BUILDAiD Beta

Code text is reproduced for reference from the Ontario Building Code (O. Reg. 163/24, 2024 Building Code Compendium). This page is provided for general information and is not an official copy. Always verify requirements against the official Ontario Building Code and confirm with your local building department.